Cleaning Hydraulic Strainer; Adjusting Brake Pedal - Toro 07213 Operator's Manual

3
Figure 54
1. Front differential
2. Fill/check plug
3. Remove drain plug and let oil flow into drain pan.
Reinstall and tighten plug when oil stops draining.
4. Clean area around fill/check plug on side of differential.
5. Remove fill/check plug and add 10W30 oil until oil is
up to hole.
6. Re–install fill/check plug.

Cleaning Hydraulic Strainer

Clean hydraulic strainer every 800 hours.
1. Position the vehicle on a level surface, stop engine,
engage the parking brake and remove key from ignition
switch.
2. Remove drain plug (Fig. 54) from side of reservoir and
let hydraulic fluid flow into drain pan.
3. Note orientation of hydraulic hose and 90 fitting
connected to strainer on side of reservoir. Remove
hydraulic hose and 90 fitting.
4. Remove strainer and clean by back flushing with a
clean degreaser. Allow to air dry before reinstalling.
1
2
3. Drain plug
50
Figure 55
1. Hydraulic strainer
5. Reinstall strainer.
6. Reinstall hydraulic hose and 90 fitting to strainer in
same orientation.
7. Reinstall and tighten drain plug.
8. Fill reservoir with approximately 7.5 qt. of Dexron IIl
ATF. Refer to Checking Hydraulic Fluid.

Adjusting Brake Pedal

Check adjustment every 200 hours.
1. Loosen jam nut on link rod ball joint.
2. Rotate rod until gap between brake pedal and up stop is
.020–.080".
3. Tighten jam nut after adjustment has been attained.
1
Figure 56
1. Link rod ball joint
1