Adjusting Shift Cables; Adjusting High-Low Cable; Adjusting Differential Lock Cable; Inspect Brakes - Toro 07213 Operator's Manual

Adjusting Shift Cables

Check adjustment every 200 hours.
1. Move shift lever to Neutral position.
2. Remove clevis pins securing shift cables to transaxle
shift arms.
2
3
Figure 61
1. Shift arm (1st – Rev.)
2. Shift arm (2nd – 3rd)
3. Loosen clevis jam nuts and adjust each clevis so cable
free play is equal forward and backward relative to hole
in transaxle shift arm (With transaxle lever free play
taken up in same direction).
4. Reinstall clevis pins and tighten jam nuts after
adjustments have been attained.
Adjusting High–low Cable
Check adjustment every 200 hours.
1. Remove clevis pin securing High–Low cable to
transaxle.
2. Loosen clevis jam nut and adjust clevis so clevis hole
aligns with hole in transaxle bracket.
3. Reinstall clevis pin and tighten jam nut after adjustment
has been attained.
Adjusting Differential Lock
Cable
Check adjustment every 200 hours.
1. Move differential lock lever to Off position.
1
3. Shift arm (High–low)
52
2. Loosen jam nuts securing differential lock cable to
bracket on transaxle.
2
Figure 62
1. Differential lock cable
2. Transaxle bracket
3. Adjust jam nuts to obtain .035"
spring hook and O.D. of hole in transaxle lever.
4. Tighten jam nuts after adjustment has been attained.

Inspect Brakes

Visually inspect brakes for worn brake shoes after every
600 hours of operation.

Inspect Tires

Check tire condition at least every 200 hours of operation.
Operating accidents, such as hitting curbs, can damage a
tire or rim and also disrupt wheel alignment, so inspect tire
condition after an accident.
Front Wheel Toe–in
After every 400 operating hours or annually, check front
wheel toe–in.
1
.035" + .025
3. Spring
.025" gap between