Jacking Vehicle; General Air Cleaner Maintenance Practices; Servicing Air Cleaner - Toro 07213 Operator's Manual

3. Push bed support onto cylinder rod, making sure
support end tabs rest on end of cylinder barrel and on
cylinder rod end (Fig. 37).
1
2
Figure 37
1. Bed support
2. Cylinder barrel
4. To store bed support, remove bed support from cylinder
and insert into brackets on back of ROPS.
5. Always install or remove bed support from outside of
bed.
6. Do not try to lower bed with bed safety support on
cylinder.

Jacking Vehicle

Danger
A vehicle on a jack may be unstable and slip off of
the jack, injuring anyone beneath it.
Do not start the vehicle while the vehicle is on a
jack.
Always remove the key from the switch before
getting off of the vehicle.
Block the tires when the vehicle is on a jack.
1. Do not start engine while vehicle is on jack, because
engine vibration or wheel movement could cause
vehicle to slip off jack.
2. Do not work under vehicle without jack stands
supporting it. The vehicle could slip off jack, injuring
any one beneath it.
3
3. Bed
44
3. The jacking point at the front of the vehicle is under the
front center frame support and at the rear it is under the
axle tube.
4. When jacking up front of vehicle, always place a 2x4
block (or similar material) between jack and vehicle
frame.
1
Figure 38
1. Front jacking point
1
Figure 39
1. Rear jacking points
General Air Cleaner
Maintenance Practices
Inspect air cleaner and hoses periodically to maintain
maximum engine protection and to ensure maximum
service life.
Check air cleaner body for damage which could
possibly cause an air leak. Replace a damaged air
cleaner body.
Clean the air cleaner filter every 50 hours and change
every 200 hours (more frequently in extreme dusty or
dirty conditions).

Servicing Air Cleaner

1. Release latches securing air cleaner cover to air cleaner
body. Separate cover from body. Clean inside of air
cleaner cover.
1
2.