Bleeding Fuel System; Driving Vehicle; Stopping Vehicle; Stopping Engine - Toro 07213 Operator's Manual

Bleeding Fuel System

1. Loosen air bleed screw on top of fuel filter/water
separator (Fig. 25).
1
Figure 25
1. Fuel filter/water separator
2. Turn key in ignition switch to the ON position. Electric
fuel pump will begin operation, thereby forcing air out
around air bleed screw. Leave key in ON position until
solid stream of fuel flows out around screw. Tighten
screw and turn key to OFF.
3. Open the air bleed screw on the fuel injection pump
(Fig. 26) with a 10 mm wrench.
1
Figure 26
1. Fuel injection pump bleeder
4. Turn key in ignition switch to the ON position. Electric
fuel pump will begin operation, thereby forcing air out
around air bleed screw on fuel injection pump. Leave
key in ON position until solid stream of fuel flows out
around the screw. Tighten screw and turn key to OFF.
2
2. Air bleeder screw
31
Note: Normally, engine should start after above bleeding
procedures are followed. However, if engine does not start,
air may be trapped between injection pump and injectors;
refer to Bleeding Air From Injectors.

Driving Vehicle

1. Release parking brake.
2. Fully depress clutch pedal.
3. Move gear shift lever to 1st gear.
4. Release clutch pedal smoothly while depressing
accelerator pedal.
5. When vehicle gains enough speed, remove foot from
accelerator pedal, fully depress clutch pedal, move gear
shift lever to next gear and release clutch pedal while
depressing accelerator pedal. Repeat procedure until
desired speed is attained.
Important
Always stop vehicle before shifting to
reverse or forward.
Note: Avoid long periods of engine idling.
Note: Leaving ignition switch in "ON" position for long
periods of time without running engine will discharge
battery.
Important Do not hold front wheels turned against the
right or left stops for longer than 5 seconds. The hydraulic
pump may over heat, resulting in pump or steering gear
damage.
6. Do not attempt to push or tow vehicle to get it started.
Damage to drive train could result.

Stopping Vehicle

To stop machine, remove foot from accelerator pedal,
depress clutch pedal, then depress brake pedal.

Stopping Engine

To stop engine, rotate ignition key to OFF and engage
parking brake. Remove key from switch to prevent
accidental starting.
New Vehicle Break–in
Your Workman is ready for work. To provide proper
performance and long vehicle life, follow these guidelines
for the first 100 operating hours.
Check the fluid and engine oil levels regularly and be
alert for indications of overheating in any component of
the vehicle.