Parking Brake - Toro 07213 Operator's Manual

4
1
3
Figure 21
1. Gear shift lever
2. Differential lock

3. Parking brake

4. High–low range shifter5
Parking Brake
Whenever the engine is shut off, the parking brake (Fig. 21)
must be engaged to prevent accidental movement of the
vehicle. To engage the parking brake, pull back on lever. To
disengage, push lever forward. Make sure parking brake is
released before moving vehicle. If vehicle is parked on a
steep grade, make sure parking brake is applied. Also, shift
the transmission into 1st gear on a uphill grade or reverse
on a down hill grade. Place chocks at the down hill side of
wheels.
Hydraulic Lift
Raises and lowers bed. Move rearward to raise, forward to
lower (Fig. 21).
Important When lowering bed, hold lever in forward
position for 1 or 2 seconds after bed contacts frame to
secure it in lowered position. Do not hold the hydraulic lift
in either the raise or lower position, for more than 5
seconds, once the cylinders have reached the end of their
travel. The hydraulic pump may over heat, resulting in
pump damage.
Hydraulic Lift Lock
Locks lift lever so hydraulic cylinders do not operate when
vehicle is not equipped with a bed (Fig. 21).
Remote Hydraulic Lever
Controls hydraulic flow to optional quick rear coupler
(Fig. 21).
5
2
6
7
5. Remote hydraulics control
6. Hydraulic bed lift
7. Hydraulic lift lock
28
High–Low Range Shifter
Adds three additional speeds for precise speed control
(Fig. 21).
Vehicle must be completely stopped before shifting
between High and Low range.
Shift only on level ground.
Depress clutch pedal fully.
Move lever fully forward for High and fully rearward
for Low.
HIGH is for higher speed driving on level, dry surfaces
with light loads.
LOW is for low speed driving. Use this range when greater
than normal power or control is required. For example,
steep grades, difficult terrain, heavy loads, slow speed but
high engine speed (spraying).
Note: There is a location between HIGH and LOW in
which the transaxle is in neither range. This should not be
used as a neutral position because the vehicle could move
unexpectedly if the HIGH–LOW shifter is bumped and the
gear shift lever is in gear.
Tilt Steering Lever
Lever on right side of console allows steering wheel to be
adjusted for operator comfort (Fig. 22).
5
1
6
3
7
Figure 22
1. Tilt steering lever
2. Ignition switch
3. Horn button
4. Coolant temp. gauge
4
8
2
5. Engine low oil pressure
light
6. Charge indicator
7. Glow plug switch
8. Glow plug indicator light