2. Remove drain plug from side of reservoir and let
hydraulic fluid flow into drain pan. Reinstall and
tighten plug when hydraulic fluid stops draining.
2
Figure 52
1. Hydraulic reservoir
3. Fill reservoir with approximately 7.5 qt. of Dexron IIl
ATF. Refer to Checking Hydraulic Fluid.
4. Start engine and operate to fill hydraulic system.
Recheck oil level and replenish, if required.
Important
Use only hydraulic fluids specified. Other
fluids could cause system damage.
Replacing Hydraulic Filter
Initially, replace the hydraulic filter after 10 operating
hours, thereafter, replace filter every 800 hours.
Use the Toro replacement filter (Part No. 54–0110).
Important
Use of any other filter may void the
warranty on some components.
1. Position vehicle on a level surface, stop engine, engage
the parking brake and remove key from ignition switch.
2. Clean area around filter mounting area. Place drain pan
under filter and remove filter.
3. Lubricate new filter gasket.
1
2. Drain plug
49
2
Figure 53
1. Hydraulic filter
4. Assure filter mounting area is clean. Screw filter on
until gasket contacts mounting plate. Then tighten filter
one–half turn.
5. Start engine and let run for about two minutes to purge
air from the system. Stop the engine and check the
hydraulic oil level and for leaks.
Change Front Differential Oil
Front Wheel Drive Only
Change front differential oil every 800 hours.
1. Position vehicle on a level surface, stop engine, engage
parking brake and remove key from ignition switch.
2. Clean area around drain plug on side of differential.
Place drain pan under drain plug.
1
2. Gasket