Ricoh MP 2014 series Operating Instructions Manual page 208

10. Troubleshooting
Problem
The printed paper is wrinkled.
The printed paper is curled.
Images are not printed in the right
position
DAC606
Images are printed diagonally to the
pages.
DAC572
Though A6 paper is loaded in the
bypass tray, an alarm sounds,
indicating the tray is empty.
206
• The paper being used may be damp. Use paper that has
been stored properly. See page 43 "Supported Paper".
• Paper is too thin. See page 43 "Supported Paper".
• If there are gaps between the paper and the paper
guides, adjust the paper guides to remove the gaps.
• Check that both the left and right fusing unit levers have
been raised to the plain paper mark.
• Load the paper upside down in the paper tray.
• If the paper curl is severe, retrieve prints from the output
tray more frequently.
• The paper being used may be damp. Use paper that has
been stored properly. See page 43 "Supported Paper".
Adjust the front end paper guide and both side paper guides
to match the paper size.
See page 60 "Loading Paper".
If there are gaps between the paper and the paper guides,
adjust the paper guides to remove the gaps.
Load paper in the bypass tray again and feed it.
Solution