Removing The Oil Filter; Installing The Oil Filter - KTM 530 EXC Owner's Manual
Hide thumbs
Also See for 530 EXC:
- Owner's manual (123 pages) ,
- Setup instructions (16 pages) ,
- Repair manual (12 pages)
Table of Contents
Advertisement
MAINTENANCE WORK ON CHASSIS AND ENGINE
Removing the oil filter
x
9.106
Warning
Danger of scalding Engine oil and gear oil get very hot when the motocycle is driven.
–
Wear suitable protective clothing and gloves. If you scald yourself, hold the affected area under cold water immediately.
Warning
Environmental hazard Problem materials cause environmental damage.
–
Dispose of oil, grease, filters, fuel, cleaning substances, brake fluid, batteries, etc. according to regulations.
Installing the oil filter
x
9.107
–
Place a suitable container under the engine.
–
Remove screws
200113-10
–
Pull the oil filter insert
Circlip pliers reverse (51012011000)
–
Completely drain the engine oil.
–
Thoroughly clean parts and sealing area.
200114-10
–
Lay the motorcycle on its side and fill the oil filter housing to about ⅓ full with
engine oil.
–
Fill the oil filter
–
Lubricate the O/ring
200114-11
–
Mount oil filter cover
–
Mount and tighten screws
Guideline
Screw, oil filter cover
–
Stand the motorcycle up.
200113-11
. Remove oil filter cover
out of the oil filter casing.
with engine oil and place it in the oil filter container.
of the oil filter cover.
.
.
M6
with O-ring.
10 Nm (7.4 lbf ft)
76
Hide quick links:
Advertisement
Table of Contents
