Refitting The Headlight Mask With The Headlight; Handlebar Position; Adjusting The Handlebar Position - KTM 530 EXC Owner's Manual

MAINTENANCE WORK ON CHASSIS AND ENGINE

Refitting the headlight mask with the headlight

9.35

Handlebar position

9.36
A 0 0 A
B 0 0 B

Adjusting the handlebar position

9.37
1 0 0 1
2 0 0 2
–
Pull out the electric plug connector
headlight.
500156-10
–
Connect the electric plug connector
500156-11
–
Position the headlight mask and fix it with the rubber band
Info
Take care with the contact of the holding lug at the fender.
–
Position the brake line and cable harness. Put the clamp on, mount and tighten
screw .

–
Check the headlamp setting.
800018-11
On the upper triple clamp, there are 2 holes at a distance of
Distance between holes

The holes on the handlebar support are placed at a distance of
Distance between holes

The handlebar supports can be mounted in 4 different positions.
400271-11
x
–
Remove the four screws
and lay it to one side.
Info
Protect the motorcycle and its attachments from damage by covering them.
Do not bend the cables and lines.
–
Remove the two screws
–
Place the handlebar support in the required position. Mount and tighten the two
screws .

400271-10
Guideline
Screw, handlebar support
Info
Position evenly the left and right handlebar supports.
and remove the headlight mask with the

.

15 mm (0.59 in)
3.5 mm (0.138 in)
. Remove the handlebar clamp. Remove the handlebar

. Remove the handlebar support.

M10 40 Nm
(29.5 lbf ft)
46
.

to each other.

from the center.

Loctite ® 243™