Avaya 9608 Administrator's Manual page 121

Category
Basic Optional
Basic Optional
IEEE 802.3
Organization
Specific
TIA LLDP MED
TIA LLDP MED
TIA LLDP MED
TIA LLDP MED
TIA LLDP MED
TIA LLDP MED
TIA LLDP MED
TIA LLDP MED
Avaya Proprietary
TLV Name (Type)
System Capabilities
Management Address
MAC / PHY
Configuration / Status
LLDP-MED
Capabilities
Network Policy
Inventory – Hardware
Revision
Inventory – Firmware
Revision
Inventory – Software
Revision
Inventory – Serial
Number
Inventory –
Manufacturer Name
Inventory – Model
Name
PoE Conservation
Level Support
About Link Layer Discovery Protocol (LLDP)
TLV Info String (Value)
Bit 2 (Bridge) will be set in the System
Capabilities if the deskphone has an internal
Ethernet switch. If Bit 2 is set in Enabled
Capabilities then the secondary port is
enabled.
Bit 5 (Telephone) will be set in the System
Capabilities. If Bit 5 is set in the Enabled
Capabilities than the deskphone is registered.
Mgmt IPv4 IP Address of deskphone.
Interface number subtype = 3 (system port).
Interface number = 1.
OID = SNMP MIB-II sysObjectID of the
deskphone.
Reports autonegotiation status and speed of
the uplink port on the deskphone.
Media Endpoint Discovery capabilities = 00-33
(Inventory, Power-via-MDI, Network Policy,
MED Caps).
Tagging Yes/No, VLAN ID for voice, L2 Priority,
DSCP Value.
MODEL - Full Model Name.
BOOTNAME.
APPNAME.
Telephone serial number.
Avaya.
MODEL with the final Dxxx characters
removed.
Provides Power Conservation abilities/settings,
Typical and Maximum Power values.
OUI = 00-40-0D (hex), Subtype = 1. Current
conservation level=POE_CONS_MODE.
2 of 3
Issue 1 May 2011 121