Avaya 9608 Administrator's Manual page 100

Administering Telephone Options
Parameter Name
PHNLDLENGTH
PHNMUTEALERT_BLOCK
PHNOL
PHNNUMOFSA
PHY1STAT
PHY2PRIO
100 Deskphone SIP 9608, 9611G, 9621G, 9641G Administrator Guide Release 6.0.1
Default Description and Value Range
Value
10 Length of national telephone number. The number
of digits in the longest possible national telephone
number. Range: 5 to 15. Needed to for "Enhanced
Local Dialing Algorithm".
1 Blocks/unblocks the Mute Alert feature. Valid
values are:
0 = Unblocked/Allowed; allows a 9621G/9641G
end user to set mute alerting via the Home screen
Settings menu.
1 = Blocked; mute alerting not allowed.
9 Outside line access code. The character(s) dialed,
including # and *, if any, to access public network
local trunks. Range: 0-2 dialable numeric digits,
including " " (Null).
" " (Null) When ENABLE_AVAYA_ENVIRONMENT=0, this
value sets the number of Session Appearances.
When the phone is in AST environment (registered
to a proxy with PPM server and Avaya CM on the
background), the phone will use the number of call
appearances sent by PPM (i.e. call-appearance
provisioned on the CM). In case this parameter is
set the phone updates this parameter and uses it
after failover to a secondary proxy. In this case,
PPM will have a higher priority than the settings
file for this parameter.
When the primary controller is set as a non-AST
proxy (a proxy without PPM and no CM in the
background, the phone is in a non-AST
environment); in this case the phone used this
parameter to set its call-appearance.
1 Ethernet line interface setting (1=auto-negotiate,
2=10Mbps half-duplex, 3=10Mbps full-duplex,
4=100Mbps half-duplex, 5=100Mbps full-duplex,
and 6=1000Mbps full-duplex if supported by the
hardware). Speed and duplex issues are
summarized and the best practice is provided in
the Avaya Application Solutions: IP Telephony
Deployment Guide, Document Number
555-245-600 Issue 6, January 2008 on page 290.
This document is available from the Avaya support
website.
0 Layer 2 priority value for frames received on or
forwarded to the secondary Ethernet interface. Set
this parameter only when VLAN separation is "1"
(enabled). Values are from 0-7 and correspond to
the drop-down menu selection.
18 of 30