Avaya 9608 Administrator's Manual page 105

Parameter Name
ROUTER
RTCPCONT
RTCPMON
RTCPMONPERIOD
RTCPMONPORT
RTP_PORT_LOW
RTP_PORT_RANGE
SCREENSAVERON
SDPCAPNEG
Administering options for the 9608, 9611G, 9621G, and 9641G SIP Deskphones
Default
Value
0.0.0.0
1
" " (Null)
5
5005
5004
40
240
1
Description and Value Range
Address(es) of default router(s) / gateway(s) in the
IP network. Range is 7-127 characters defining
one or more IP Addresses in dotted decimal
format, separated by commas without any
intervening spaces.
Enables/disables the RTCP in parallel to RTP
audio streams. Values are 0=RTCP disabled,
1=RTCP enabled.
RTCP Monitor IP or DNS address to be used as
destination for RTCP monitoring. Zero to 255
characters: zero or one IP addresses in dotted
decimal or DNS name format. Note that this value
is only set via SET command in settings file if
operating in a NON-Avaya environment,
otherwise this value is retrieved via PPM.
RTCP Monitor report period. Valid range = 5 - 30
Interval in seconds for sending out RTCP
monitoring reports.
RTCP monitor port number. TCP/UDP port to be
used as destination port for RTCP monitoring.
Valid range is 0-65535. Note that this value is only
set via SET command in settings file if operating in
a NON-Avaya environment, otherwise this value is
retrieved via PPM.
Specifies lower limit of a port range to be used by
RTP/RTCP or SRTP/SRTCP connections, for
example, to adapt to firewall traversal policies.
Values: 1024-65503.
Specifies the width of the port range to be used by
RTP/RTCP or SRTP/SRTCP connections, for
example, to adapt to firewall traversal policies. The
upper limit is calculated by the value of
RTP_PORT_LOW plus the value of
RTP_PORT_RANGE, taking into consideration the
overall limit of 65535. Values: 32-64511.
Number of idle time minutes after which the screen
saver is turned on. Valid values range from zero
(disabled) to 999 minutes (16.65 hours).
Controls SDP capability negotiation; interaction
between the SDPCAPNEG and
MEDIAENCRYPTION parameters controls INVITE
behavior. Valid values are:
1 = SDP capability negotiation is enabled.
0 = SDP capability negotiation is disabled.
23 of 30
Issue 1 May 2011 105