HP J2600A Installation Manual page 94

If the router module is not using either the factory-default or a Smart-
Boot Helper configuration when you reset it or when you power on or
reset the hub, the router module does not send Bootp requests over its
ports, but simply boots using the configuration that was most recently
saved. (If you have made and saved any changes to the configuration,
the router module is no longer in the factory-default state—even if the
system name is still DEFAULT_CONFIG.)
If you have made and saved changes to either the factory-default
configuration or a SmartBoot configuration, and subsequently you want
to return to a SmartBoot configuration:
1. Make sure there is a network link between the router module's WAN
port or internal LAN port and the HP router or Bootp server on
which the SmartBoot configuration was set up.
2. Clear the router module (refer to page 3-7).
The router module restores the factory-default configuration,
reboots, then sends out Bootp requests as described on page C-2.
If the router module is using a SmartBoot configuration or you have
made and saved changes to the factory-default configuration, and
subsequently you want to return to the factory-default configuration:
1. Disconnect the network link between the router module's WAN port
or internal LAN port and the HP router or Bootp server on which the
SmartBoot configuration was set up.
Disconnecting the network link will prevent the router module from
receiving a SmartBoot configuration when the router module is
rebooted (after you clear it in the next step).
2. Clear the router module (refer to page 3-7).
The router module restores the factory-default configuration,
reboots, then sends out Bootp requests as described on page C-2.
3. When the Main Menu screen appears, wait for the following message
to appear on the second line:
BOOTP failed. Use Smartboot Helper to continue
The appearance of this message indicates that the router module is
no longer sending out Bootp requests.
SmartBoot
C-3