HP J2600A Installation Manual page 37

Installation
Using the Main Menu and NCL
Several of the procedures in this chapter require using NCL (Network
Control Language Interpreter) commands.
To use NCL commands:
1. At the Main Menu screen, press [2 ].
The NCL prompt appears. This prompt matches the current system
name. For example, if the system name is DEFAULT_CONFIG, the
NCL prompt appears as shown below:
Figure 2-2. Default NCL Prompt
2. Type the NCL command, then press [Enter].
3. To exit from NCL and return to the Main Menu screen, enter the NCL
Exit command:
For more information about using NCL, refer to the User's Guide.
2-4
NCL prompt
exit [Enter]