HP J2600A Installation Manual page 74

Troubleshooting
Diagnostic Tests
Ping
Ping is a network-layer test that sends an Internet Control Message
Protocol (ICMP) echo request message to another node that has an IP
address and is able to respond to an ICMP echo request message. The
router must have IP routing or IP host-only mode configured in order to
use this test.
1. At the NCL prompt, enter one of the following commands:
where:
2. You will see a message, either that the target node is alive—meaning
that communications are passing successfully from the router to the
remote node on a specific link—or that the remote node did not
respond. If you cannot reach any remote node, the problem must be
isolated to the router, the links used in the test, or all of the remote
nodes.
For more details, refer to the Operator's Reference.
4-12
ping x.x.x.x
ping x.x.x.x count
ping x.x.x.x count wait
x.x.x.x is the target node's IP address in dotted decimal
notation.
count (optional) is the number of times to repeat the echo
request packet. If count is not included, the packet is sent once.
wait (optional) is how many seconds to wait for a response. If
a second integer is not included, the response must be received in
five seconds to be successful.