HP J2600A Installation Manual page 21

Installation
3. Install the Router Module.
To install the router module:
1. Using a Torx T-10 or flat-blade screwdriver, loosen the two captured
screws holding the cover plate over the hub's Expansion Slot, then
remove the cover plate. Note that the screws are spring-loaded and
will release outward when unscrewed far enough. Do not unscrew
them completely from the cover plate.
Figure 1-3. Cover Plate Screws
2. Wrap one end of a grounding wrist strap (one is supplied with the
router module) around your wrist. Connect the other end as follows:
• If using the grounding wrist strap supplied with the hub, connect
the other end to the unpainted surface at the left of the hub's
Expansion Slot.
• If using a grounding wrist strap that has an alligator clip at the
other end, connect the clip to the left screw on the back of the
hub.
Connect grounding
... or here
wrist strap here ...
Figure 1-4. Connecting Grounding Wrist Strap
Loosen these two screws
1-11