HP J2600A Installation Manual page 78

Troubleshooting
Replacing the Battery
8. Using your fingers (or a nonmetallic tool), carefully lift up the
battery clip slightly, then slide the battery out of its holder.
Figure 4-1. Removing Battery
C a u t i o n
Replace the battery only with the same type.
9. Carefully insert the new battery—positive (+) side up—into the
battery holder.
10. Reassemble the the router module with the SNMP module, then rein-
stall them in the hub, as described in steps 6 – 12 on pages 1-13 – 1-15.
W A R N I N G
Dispose of the used battery properly. Do not attempt to recharge,
crush, or disassemble it; do not incinerate it or expose it to heat
above 100°C (212°F).
4-16