HP J2600A Installation Manual page 16

Installation
1. Check the Version of the SNMP Module.
2. Look at the exposed edge of the SNMP module.
• If an LED is mounted near the button switch, the installed SNMP
• If there is no LED there, the module is the HP J2603A version;
Button switch
If this LED is present,
the SNMP module is
the proper version
Figure 1-2. Checking SNMP Module
3. If you will not be installing the router module now, reinstall the cover
plate:
a. Insert the tabs on the bottom of the cover plate in the small slots
b. Close the cover plate, then tighten the two captured screws using
1-6
module is the HP J2603B version; you can proceed with installing
the router module.
contact your HP dealer for information about obtaining the
HP J2603B version.
in the bottom of the Expansion Slot.
a Torx T-10 or flat-blade screwdriver. Be careful not to
overtighten them.