Mitsubishi Electric FR-F500 Series Instruction Manual page 102

When 100 is set in Pr. 52, the monitored values during stop and during operation differ as indicated below:
(The LED on the left of Hz flickers during a stop and is lit during running.)
operation/during stop
Output frequency
Output current
Output voltage
Alarm display
Note: 1. During an error, the output frequency at error occurrence is displayed.
2. During MRS, the values are the same as during a stop.
Note: 1. The monitoring of items marked × cannot be selected.
2. By setting "0" in Pr. 52, the monitoring of "output frequency to alarm display" can be selected in
sequence by the
3. *"Frequency setting to output terminal status" on the PU main monitor are selected by "other
monitor selection" of the parameter unit (FR-PU04).
4. **The load meter is displayed in %, with the current set in Pr. 56 regarded as 100%.
5. The actual operation time displayed by setting "23" in Pr. 52 is calculated using the inverter
operation time. (Inverter stop time is not included.) Set "0" in Pr. 171 to clear it.
6. When Pr. 53 = "0", the level meter display of the parameter unit can be erased.
7. By setting "1, 2, 5, 6, 11 or 17" in Pr. 53, the full-scale value can be set in Pr. 55 or Pr. 56.
8. The cumulative operation time and actual operation time are calculated from 0 to 65535 hours,
then cleared, and recalculated from 0.
When the operation panel (FR-DU04) is used, the display shows "----" after 9999 or more hours
have elapsed.
Whether 9999 or more hours have elapsed or not can be confirmed on the parameter unit
(FR-PU04).
9. The actual operation time is not calculated unless the inverter has operated for longer than one
hour continuously.
10.When the operation panel (FR-DU04) is used, the display unit is Hz, V or A only.
REMARKS
For the monitor set in Pr. 52, its display position depends on the set value.
Factory setting
* The monitor displayed at power-on is the first monitor. For the setting method of the first monitor, refer to
page 49.
First monitor (It is shown at power-on)
FR-DU04
CONTROL PANEL
Hz
A
V
MON EXT PU
REV FWD
Output frequency monitor
1) Displayed on the third monitor when the set value is "5 to 14"
First monitor
Output frequency monitor
2) Displayed on the second monitor instead of output current monitor when the set value is "17, 24"
First monitor
Output frequency monitor
3) Displayed on the third monitor instead of output current monitor when the set value is "20, 23, 25"
First monitor
Output frequency monitor
Pr. 52
0
During
During stop
Output frequency Set frequency
Output current
Output voltage
Alarm display
key.
SET
Second monitor
FR-DU04
CONTROL PANEL
Hz
SET
A
V
MON EXT PU
REV FWD
Output current monitor
2)
Second monitor
SET
Output current monitor
Second monitor
SET
Set value "17, 24"
monitor
Second monitor
SET
Output current monitor
100
During operation
Output frequency
Third monitor
FR-DU04
CONTROL PANEL
Hz
SET
A
V
MON EXT PU
REV FWD
Output voltage monitor
3)
1)
Third monitor
SET
Set value "5 to 14" monitor
Third monitor
SET
Output current monitor
Third monitor
SET
Set value "20, 23, 25"
monitor
89
PARAMETERS
Alarm monitor
FR-DU04
With alarm CONTROL PANEL
Hz
SET
A
V
MON EXT PU
REV FWD
SET
4