Top Section Burner Valve; Switch Replacement; Motor Replacement - Vulcan-Hart G260 Service Manual

ENDURANCE SERIES GAS RANGES - REMOVAL AND REPLACEMENT OF PARTS
TOP SECTION BURNER
CONTROL VALVE
WARNING: DISCONNECT THE
ELECTRICAL POWER TO THE
MACHINE AND FOLLOW LOCKOUT /
TAGOUT PROCEDURES.
WARNING: SHUT OFF THE GAS BEFORE
SERVICING THE UNIT.
WARNING: ALL GAS JOINTS DISTURBED
DURING SERVICING MUST BE CHECKED FOR
LEAKS. CHECK WITH A SOAP AND WATER
SOLUTION (BUBBLES). DO NOT USE AN
OPEN FLAME.
1. Remove the oven manifold cover as outlined
under COVERS AND PANELS.
2. Allow the range to cool completely.
3. Remove the burner grates and deflectors,
if necessary.
4. Remove the griddle plate assembly, if necessary.
5. Remove the burner mounting screws.
6. Carefully move the burner assembly away from
the burner control valve.
7. Remove the burner control valve from the manifold.
8. Clean the manifold of any thread sealant.
9. Inspect the control valve for wear and damage,
replace as necessary.
10. Reverse the procedure to install a new burner
control valve.
NOTE: Apply a light coat of thread sealant to the
control valve threads before installing the burner
control valve in the manifold.

SWITCH REPLACEMENT

WARNING: DISCONNECT THE
ELECTRICAL POWER TO THE
MACHINE AND FOLLOW LOCKOUT /
TAGOUT PROCEDURES.
1. Remove the oven manifold cover as outlined
under COVERS AND PANELS.
2. Allow the range to cool completely.
3. Disconnect wiring from the switch.
4. Remove the switch from mounting.
5. Reverse the procedure to install the
replacement switch.

MOTOR REPLACEMENT

WARNING: DISCONNECT THE
ELECTRICAL POWER TO THE
MACHINE AND FOLLOW LOCKOUT /
TAGOUT PROCEDURES.
NOTE: A centrifugal switch is mounted inside the
motor assembly. If electrical voltage is available to
the motor, the motor and switch must be replaced.
1. Remove cover from the motor junction box.
2. Disconnect motor wiring at the junction box.
3. If necessary, remove the motor guard.
Page 11 of 23 F35425 (October 2005)