Olympus C-2100 Ultra Zoom Instructions Manual page 195

SYMPTOM
No picture is taken when the Shutter button is pressed.
POSSIBLE CAUSES
4
The card is full.
5
The batteries ran out.
6
Indications disappear on
the viewfinder/monitor or
the control panel. On the
control panel, the battery
remaining power
indicator will blink.
7
The memory gauge is
full.
8
A write-protect adhesive
seal is placed on the
card or there is no card
in the camera.
9
The Mode dial is set to
.
SYMPTOM
The date recorded with the image data is wrong.
POSSIBLE CAUSES
1
The date was not set.
2
The camera has been
left for approx. 1 week
with the batteries
removed and the date
setting is canceled.
CORRECTIVE ACTION
4
Replace the card, delete
unwanted pictures or transfer
the data to a computer and
delete all of the pictures.
5
Replace the batteries with
new ones.
6
Replace the batteries with
new ones. (Do not open the
Battery compartment cover
when the Card access lamp is
blinking.)
7
Wait until there is room in the
memory gauge.
8
Insert a new card in the
camera.
9
Set the mode dial to P, A, S,
M, S-Prg or .
CORRECTIVE ACTION
1
Set the date. It is also
possible to set the date via a
personal computer using
CAMEDIA Master. The clock
adjustment is not factory-
preset.
2
Try setting the date again.
REF. PAGE
P. 40–42
P. 78
P. 180–189
P. 33
P. 33
P. 69
P. 40
P. 41
P. 44
REF. PAGE
P. 54
P. 54
195