Olympus C-2100 Ultra Zoom Instructions Manual page 108

RECORDING—using the flash(Cont.)
1
Slide the flash switch to the left to
pop up the flash.
The flash does not fire in the movie
recording mode (
2
Press until the desired flash
mode appears on the control
panel.
Each time you press
mode will switch from AUTO-
FLASH [RED-EYE REDUCTION
FLASH (
( ).
3
Press the Shutter button halfway
down.
When the flash mark (
the display, the flash is ready to
fire.
If the flash mark (
the flash is charging. In this case,
release the Shutter button and wait
until the flash mark lights steadily
before taking the picture.
Pay attention to the "Notes" for
each mode (p.106/107).
4
Press the Shutter button all the
way down.
The flash does not function in the Bracketing (p.102), Picture Effects
(WHITE BOARD/BLACK BOARD) (p.137) and Panorama modes(p.135).
The flash may not give you the results you want in the Macro mode,
especially with wide-angle shooting. Check your results on the Monitor. If a
conversion lens is attached to the lens, it may reduce the output of the
flash.
Unless OFF is selected in All Reset, the setting will be canceled and reset
to Auto-Flash when the power is turned off (p.148).
108
).
, the flash
)[ FILL-IN FLASH
) lights on
) is blinking,
Flash mode
Note:
3, 4
2
Flash mark
P F2.8 1/30
Control panel
1
0.0