Emulation Mode - Oki Microline 8810 User Manual

The default is Power Up. Change the setting to Select if the DTR
signal is required when the printer is selected.
Eject Direction
Applies only if the optional CSF is installed.
Change to FF Code if you want the printer to eject a cut sheet
when it receives the FF command.
Eject Dir.
Choose where the paper is ejected when you are using manual
feed from the platform or the optional CSF(s): Front [the
default] or Rear.

Emulation Mode

Choose the printer emulation: IBM PPR [the default], , Epson FX,
or ML (Oki Microline).
ESC SI Pitch
IBM emulation only.
Sets the character pitch used when the ESC SI command is
received. Select 17.1 cpi [the default] or 20 cpi.
FF Function
Applies to the manual feed from the platform.
Sets what happens when the printer receives the FF command.
Eject [the default] or Form Feed.
Form Tear-Off
The default is Off. To activate Form Tear-Off, change the setting
to On.
The Forms Tear-Off feature allows a printed continuous form
page to be torn off without wasting paper or adjusting the
printer.
For more information, see page 75.
Front Load Adj.
For fine tuning the Top of Form (TOF) location when using
continuous forms (front feed). Settable from -40 to +40 in
increments of 1/144 inch. The default is 0.
Microline 8810 User's Guide
55