Oki Microline 8810 User Manual page 62

PE Adj. [Paper End Adjust]
For fine tuning the location of the last line of printing (Paper End)
for a specific paper feed path. See below for a list of paper feed
paths.
Settable from -15 to +15 in increments of 1/144-inch. The
default is 0.
Negative values allow printing further down on the form.
• Paper End moves down
• paper moves up.
Positive values stop the printing further up on the form.
• Paper End moves up
• paper moves down
Paper Feed Paths
• PE Adj. (Cut)
Applies to sheets fed manually through the platform.
• PE Adj. (CSFF)
Applies to sheets fed through the optional CSF mounted on
the front of the printer.
• PE Adj. (CSFR)
Applies to sheets fed through the optional CSF mounted on
the rear of the printer.
• PE Adj. (Front)
Applies to continuous forms fed through the front tractor.
• PE Adj. (Rear)
Applies to continuous forms fed through the optional Rear
Push Tractor.
PE Pos. [Paper End Position]
This sets when the the printer will move to the next continuous
form, based on the distance between the center of the
characters on the last line of the form and the bottom of the
form. Available settings: 3.18 mm (1/8") or 6.35 mm (1/4")
[the default].
Microline 8810 User's Guide
62