Oki Microline 8810 User Manual page 51

Available settings: Align 1 [the default], Align 2, Align 3, Align 4,
or Invalid (skew adjustment disabled).
Auto Align Detect
Detects and corrects paper skew when manual feed through the
platform is being used with Auto Align enabled [the default].
Available settings: Valid Level 1, Valid Level 2 [the default], or
Invalid.
Change to Valid Level 1 if you wish the detection to be more
precise.
Change to Invalid if you are experiencing difficulty getting forms
to load into the printer when using preprinted forms with
anomalies at the top such as a large dark area on one side or a
cutout. Such types of forms defeat the skew sensor.
Auto Align (POW)
Note This setting interacts with the other "Align" items in the
Manual Feed group.
Sets the alignment method (skew adjustment) engaged for
manual feed from the platform when the printer is turned on.
Note This setting does not affect the printer when it initializes in
response to an I-Prime signal.
Available settings: Align 1, Align 2, Align 3, Align 4, or
SelectAutoAlign [the default].
• Select Auto Align [the default]: Skew adjustment is set by Auto
Align in the Manual Feed group. See page 38.
• Align x (x = 1, 2, 3, or4): Skew adjustment is set by the
corresponding Alignx Pos.Adj in the Manual Feed group. See
page 50.
Auto CR
IBM emulation only.
Form Unusable with Auto Align.bmp
See page 38.
Microline 8810 User's Guide
51