Switch Between Single Sheets And Continuous Forms - Oki Microline 8810 User Manual

6. Close the tractor covers and fine tune the position of the right tractor
until the holes in the paper are centered on the pins, then push back the
right tractor lock lever.
7. Lower the platform.
8. Position the continuous forms stack below the printer with no more than
about 1 inch (3 cm) offset (1).

Switch between Single Sheets and Continuous Forms

Note If the optional Cut Sheet Feeder (CSF) and/or Rear Push Tractor are
installed, additional paper paths (e.g., Front CSF, Rear CSF, etc.)
appear on the display.
8810_3_crop.JPG
Microline 8810 User's Guide
23
F5-07a.JPG
F5-08a.JPG