Host Interface - Oki Microline 8810 User Manual

Oki microline printer users' guide
Hide thumbs Also See for Microline 8810:
Table of Contents

Advertisement

Gap Pos.
When Auto Gap detection is enabled, this sets how far in from
the left edge of the form the gap detection begins: 2 inches (51
mm) [the default] or 4 inches (102 mm).
Graphics
The default is Bi-directional. Changing to Uni-directional will
improve the print registration, but slow the print speed.
Graphics Data
Sets graphics data to print 7 Bits [the default] or 8 Bits.
High Skip
The default is Yes. This enables the low-vibration mode, which
reduces printer vibration during printing. To switch low-vibration
mode off, change this setting to No.

Host Interface

Choose the interface mode: Auto Interface [the default],
Parallel, USB, or Option I/F.
I-Prime
The default is Enable: print out the buffer contents when the
I-Prime signal is received. Change to Disable if you wish the
printer to ignore the I-Prime signal.
I/F Time Out
Appears only if Host Interface is set to Auto Interface [the
default].
Choose the amount of time the printer waits (while receiving
data) before going into idle mode: 15 sec [the default], 30 sec,
45 sec, 1 min, 2 min, 3 min, 4 min, or 5 min.
If your software spends a long time processing between portions
of data it feeds to the printer, choose a longer time interval value
to keep your printer from dumping the received data while it is
waiting for more.
Impact Mode
Selects the print mode, Normal [the default] or Quiet, engaged
on power up.
Microline 8810 User's Guide
58

Hide quick links:

Advertisement

Table of Contents
loading

This manual is also suitable for:

Ml8810nMl8810

Table of Contents