Table of Contents
Advertisement
126 Using System features
Pause
ƒ‡°
The Pause feature enters a 1.5 second delay in a dialing sequence on an external
line. This is often required for signaling remote devices, such as answering
machines, or when reaching through to PBX features or host systems.
You can program more than one pause in an external autodial or speed dial
sequence.
The Pause symbol (
For pulse dialing,
Long Tones
ƒ°‚°
The Long Tones feature allows you to control the length of a tone so that you can
signal devices such as fax or answering machines which require tones longer than
the standard 120 milliseconds.
1. While on a call, press
2. Press the dial pad buttons to produce the appropriate tones. Each tone sounds
for as long as you hold down the button.
Long tones can be used on any call except a conference call. You can use internal
lines of the Enterprise Edge system to activate a device connected to an Enterprise
Edge ATA2 or an ASM in another area of your office, or external lines to access
devices outside the Enterprise Edge system.
Displays
Long Tones:
Programmed Release
ƒ•°·
The Programmed Release feature performs same function as
dialing sequence. When the system encounters Programmed Release in a dialing
sequence, it stops dialing and hangs up the call.
The Programmed Release symbol (
programmed dialing sequence.
The system ignores any digits or commands that follow a Programmed Release in
a programmed dialing sequence.
Enterprise Edge Feature Programming Telephone Guide
) uses one of the 24 spaces in a dialing sequence.
›
inserts a 1.5 second pause into the dialing sequence.
•
ƒ°‚°
At the appropriate time, press any dial pad
button. Hold each button down for as long as
necessary. Press
ƒ
to cancel Long Tones.
) takes up two of the 24 spaces in a
fi
.
or
˙
in a programmed
®
P0908510 Issue 01
Advertisement
Table of Contents
