Saving Captured Data; Configuring And Running Packet Capture Objects; Creating A Capture Object - Nortel NN46110-602 Troubleshooting Manual

For example, enter:
CES(capture-ethernet)

Saving captured data

To set the PCAP capture mode to loss or no loss, from CLI Capture Configuration
Mode enter:
capture-all
or
No capture-all
For example, enter:
CES(capture-ethernet)

Configuring and running packet capture objects

This section provides instructions for creating, configuring, starting, and stopping
capture objects, as well as instructions for saving captured traffic to a file on disk.
For the complete syntax of the packet capture commands shown in this section,
see the Nortel VPN Router Using the Command Line Interface.

Creating a capture object

To create a capture object, use the
the types of object that you can create, see
1 To view the types of capture objects that you can configure, enter the
following command at the Privileged EXEC prompt.
capture add <object_name> ?
CES#
#maxfiles 99
#capture-all
capture add
"Capture types" on page
Nortel VPN Router Troubleshooting
Chapter 5 Packet capture 115
command. (For information about
106.)