To Install The Cable - Nortel CallPilot 201i Hardware Installation

November 2006

To install the cable

.
1 Attach the bracket assembly and cable as follows:
a. Below the card cage, temporarily remove the hardware that secures
cable connections to the Option 11C.
b. Temporarily remove any cabling that may interfere with the
installation of the intermediate SCSI cable bracket assembly.
ATTENTION
c. Remove the two screws on the right side of the Option 11C I/O panel.
d. Attach the intermediate SCSI cable bracket assembly, using the
screws that were removed previously, so that the SCSI connector
appears on the right side of the Option 11C cabinet.
201i Server Hardware Installation
Installing the 201i server in an Option 11C or Option 11C Mini
CAUTION
Risk of equipment damage
You must power off the 201i server before connecting or
disconnecting SCSI cables.
Before you disconnect the cabling, take the
telephony equipment services associated with the
cabling out of service.
81