Getting Started; Requirements; Enabling The Bbi; Cli Configuration Tasks - Nortel 5100 Series Release 2.3.3 User Manual

Nortel Switched Firewall Browser-Based Interface Users Guide

Getting started

Requirements

Following are the requirements to enable the BBI:
An installed Nortel Switched Firewall
A Check Point policy to allow management station access for HTTP or HTTPS traffic
A PC or workstation with network access to the Firewall host IP address
A Frame-capable web browser software, such as the following:
JavaScript enabled in your web browser
Java 2 Runtime Environment SE plug-in, version 1.2.4-01 or higher
N
OTE
browser.

Enabling the BBI

Before you can access the BBI, you must perform some configuration at the CLI. For
information about accessing and using the CLI, see the Nortel Switched Firewall 2.3.3 User's
Guide and Command Reference,(213455-L).

CLI configuration tasks

Following are the CLI configuration tasks required to enable access to the BBI:
Enable the BBI.
Generate a temporary certificate (if using HTTPS).
Apply the changes.
Use the access list to permit remote access to trusted clients.
Use the Check Point SmartDashboard on your SMART Client to add a security policy that
allows BBI traffic.
12 Introduction
Netscape Navigator 4.6 or higher
Internet Explorer 5.5 or higher
–
JavaScript is different from Java. Ensure that JavaScript is enabled in your web
216383-D October 2005