Nortel 5100 Series Release 2.3.3 User Manual page 43

Fields and buttons on the Cluster/Logs/Syslog form are as follows:
System Log
Debug Messages displays a list with two choices.
Source IP Mode displays a list with three choices.
Update submits the debug message status change and the source IP mode change to the
pending configuration.
The Remote Syslog Servers section of the Cluster/Logs/Syslog form is divided into the
following two sections:
Current Remote Syslog Servers
Add New Remote Syslog Server
Current Remote Syslog Servers displays the following fields:
IP Address specifies the remote syslog server in dotted decimal notation.
Logging Severity specifies the severity of messages logged. All messages of the selected
severity or higher are logged.
Facility provides the local facility number used to uniquely identify syslog entries.
Action—Click Delete to delete an active remote server.
Add New Remote Syslog Server displays the following fields:
New Server IP specifies the IP address for the remote syslog server. TIP: Enter the IP
address in dotted decimal notation.
New Server Severity specifies the severity of messages logged. The following selections
are presented in the list:
216383-D October 2005
Nortel Switched Firewall Browser-Based Interface Users Guide
Disabled disables transmission of debug messages to the local system log.
Enabled enables transmission of debug messages to the local system log.
Auto, the default setting, specifies the IP address of the outgoing interface.
Unique specifies the IP address of the individual NSF.
MIP specifies the IP address of the cluster MIP. Use this setting with applications
designed for devices limited to one IP address (for example, some versions of
HP OpenView).
emerg
alert
Browser-Based Interface forms reference 43