American Dynamics illustra 600 Installation & Operation Manual page 23

Method 4: To surface mount using junction box
1. Tie your wiring into a junction box and feed the leads through the top knock-out on the back case.
2. Tighten the electrical screws to secure the back case to the junction box. Then connect the wiring.
3. Align the back case and the lens, and then fasten the three screws. There is a red dot on the base
case and the lens base respectively. Use the dots to align the case and the base.
4. Adjust the focusing position by rotating and panning the camera base. Note that the back case side
conduit hole is the point where the camera will not rotate past.
2. Camera Installation
Use the red dots
on back case
and lens base for
alignment.
Side conduit hole
15