2. Camera Installation
Method 3: To surface mount
1. According to your needs, use the top or side knock-out on the back case for cable entry and connect
the wiring. Mount the back case on a surface with screws.
2. Align the back case and the lens base, and then fasten the TP4 screws into the inserted anchors.
There is a red dot on the back case and the lens base respectively. Use the dots to align the case and the
base.
3. Adjust the focusing position by rotating and panning the camera base. Note that the back case side
conduit hole is the point where the camera will not rotate past.
4. Use the supplied security torx key to tighten the three cover screws to replace the dome cover.
5. Finally, insert the screw hole plugs to the three cover screws.
14
Top knock-out
Side knock-out
Use the red dots on back
case and lens base for
alignment.
Side conduit hole
Installation & Operation Guide