Frame Assembly - NordicTrack NTSY59210 User Manual

Frame Assembly

1.
Before beginning, read the information on
page 5. This brief introduction will save you
much more time than it takes to read it.
Press three 50mm Square Inner Caps (72) into
the Press Base (1).
Insert four M10 x 67mm Carriage Bolts (87) and
two M10 x 72mm Carriage Bolts (73) up through
the bottom of the Press Base (1). Place the Press
Base flat on the floor. Note: If the Bolts fall out,
place a piece of tape over the bolt heads to
hold them in.
2. Press two 50mm Square Inner Caps (72) into the
extensions on the Rear Base (2). Press a 50mm x
75mm Inner Cap w/ Slot (95) into the end of the
Rear Base. Insert four M10 x 67mm Carriage Bolts
(87) up through the bottom of the Rear Base.
Slide the Rear Base (2) onto the two M10 x
72mm Carriage Bolts (73) in the Press Base (1).
Attach the Rear Base to the Press Base with two
M10 x 70mm Bolts (79), two M10 Washers (89),
and two M10 Nylon Locknuts (93). Do not tight-
en the Locknuts yet.
Note: If you have purchased the hack squat
extension (model NTSY3921), do not insert the
four M10 x 67mm Carriage Bolts (87) or the
50mm x 75mm Inner Cap w/ Slot (95) into the
Rear Base (2). Instead, complete step 2 in the
NTSY3921 manual.
3. Attach the Right Upright (17) to the two M10 x
72mm Carriage Bolts (73) in the Press Base (1)
and Rear Base (2) with two M10 Nylon Locknuts
(93). Do not tighten the Locknuts yet. Make
sure the rod is on the indicated side of the
Upright.
1
87
72
2
93
89
89
1
3
17
93
1
6
72
72
1
73
87
79
72
2
73
95
87
Rod
93
73
2