NordicTrack NTSY59210 User Manual page 9

9. See the inset drawings. Press the two Top
Weight Bushings (33) into the Top Weight (32).
Press two 5-pound Weight Bushings (104) into
each 5-pound Weight (34). Press two 10-pound
Weight Bushings (61) into each 10-pound Weight
(29).
Slide a Weight Bumper (28) onto each Weight
Guide (27). Slide the sixteen 10-pound Weights
(29), the seven 5-pound Weights (34), and the
Top Weight (32) onto the Weights Guides in the
order shown.
10. Press a 50mm Square Inner Cap (72) into the
extension on the Rear Top Frame (19). Press two
Weight Guide Bushings (57) into the Rear Top
Frame.
Set the Rear Top Frame (19) onto the two Weight
Guides (27).
Attach the Rear Top Frame (19) to the Press Top
Frame (13) with two M10 x 70mm Bolts (79), two
M10 Washers (89), and two M10 Nylon Locknuts
(93).
Attach the Rear Top Frame (19) to the Left
Upright (20) with two M10 x 45mm Bolts (86), two
M10 Washers (89), and two M10 Nylon Locknuts
(93). Note: If you have purchased the hack
squat extension (model NTSY3921), do not
use the two M10 x 45mm Bolts (86) and two
M10 Washers (89). Instead, complete steps 3–8
in the NTSY3921 manual.
Do not tighten the M10 Nylon Locknuts (93)
yet.
11. Slide two M8 x 90mm Bolts (90) through two M8
Large Washers (53), two 15mm x 30mm Spacers
(23), the Rear Top Frame (19), the Weight Guides
(27), and two more 15mm x 30mm Spacers.
Tighten the M10 Nylon Locknuts (93) used in
steps 2–10.
9
33
104
32
34
10
79
89
11
9
27
32
34
29
28
28
61
29
19
93
72
93
93
93
57
13
89
27
86
20
90
53
23
19
53
23
23
27