NordicTrack NTSY59210 User Manual page 13

23. Wrap the Press Cable (101) around a 115mm
Pulley (54). Attach the Pulley to the bracket on
the Press Upright (16) with an M10 x 45mm Bolt
(86) and an M10 Nylon Locknut (93).
24. Wrap the Press Cable (101) up around a 115mm
Pulley (54). Attached the Pulley to the bracket on
the Press Frame (12) with the M10 x 70mm Bolt
(not shown) used in step 22, and an M10 Nylon
Locknut (93).
Attach the end of the Press Cable (101) to the
indicated bracket on the Press Upright (16) with
an M10 x 25mm Short Thread Bolt (105) and an
M10 Nylon Locknut (93).
25. Locate the High Cable (100). Route the end of
the Cable without the ball up through the Press
Top Frame (13).
Wrap the High Cable (100) around a 115mm
Pulley (54). Attach the Pulley inside the Press Top
Frame (13) with an M10 x 65mm Bolt (88), two
M10 Washers (89), two 15mm x 12mm Spacers
(62), and an M10 Nylon Locknut (93).
26. Route the end of the High Cable (100) through
the indicated slot, around a 115mm Pulley (54),
and down through the Press Top Frame (13).
Attach the 115mm Pulley (54) inside the Press
Top Frame (13) with an M10 x 65mm Bolt (88),
two M10 Washers (89), two 15mm x 12mm
Spacers (62), and an M10 Nylon Locknut (93).
23
93
54
24
93
12
54
25
100
93
89
62
26
93
89
Slot
13
13
Bracket
86
16
101
Bracket
105
101
93
16
54
13
89
62 88
54
100
62
62
89
88