Power Connector Cable - HP EliteBook 8560w Maintenance And Service Manual

Power connector cable

NOTE:
Before removing the power connector cable, follow these steps:
1. Shut down the computer. If you are unsure whether the computer is off or in Hibernation, turn
the computer on, and then shut it down through the operating system.
2. Disconnect all external devices connected to the computer.
3. Disconnect the power from the computer by first unplugging the power cord from the AC outlet,
and then unplugging the AC adapter from the computer.
4. Remove the battery (see
5. Remove the service access cover (see
6. Remove the following components:
a.
b.
c.
d.
e.
f.
Remove the power connector cable:
1. Position the computer right-side up, with the front toward you.
2. Remove the tape (1) from the top of the power connector cable.
3. Lift the power connector cable (2) up from the routing in the rear of the base enclosure.
Downloaded from LpManual.com Manuals
The power connector cable is included in the Cable Kit, spare part number 652662-001.
Battery on page
Hard drive (see Hard drive on page
Optical drive (see Optical drive on page
Keyboard (see Keyboard on page
Top cover (see Top cover on page
Video card fan/heat sink assembly (see
Processor heat sink (see
48).
Service access cover on page
60)
65)
67)
71)
Video card fan/heat sink assembly on page
Processor heat sink on page
50).
86)
Component replacement procedures 105
84)