Service Access Cover Latch - HP EliteBook 8560w Maintenance And Service Manual

Service access cover latch

NOTE:
number 652649-001.
Before removing the service access cover latch, follow these steps:
1. Shut down the computer. If you are unsure whether the computer is off or in Hibernation, turn
the computer on, and then shut it down through the operating system.
2. Disconnect all external devices connected to the computer.
3. Disconnect the power from the computer by first unplugging the power cord from the AC outlet,
and then unplugging the AC adapter from the computer.
4. Remove the battery (see
5. Remove the service access cover (see
6. Remove the following components:
a.
b.
c.
d.
e.
f.
g.
h.
Remove the service access cover latch:
1. Position the computer right-side up with the front toward you.
2. Remove the three Phillips M2.0×2.0 screws (1) that secure the service access cover latch to the
base enclosure.
Downloaded from LpManual.com Manuals
The service access cover latch is included with the base enclosure assembly, spare part
Battery on page
Hard drive (see Hard drive on page
Optical drive (see Optical drive on page
Keyboard (see Keyboard on page
Top cover (see Top cover on page
Video card fan/heat sink assembly (see
Processor heat sink (see
System board (see System board on page
RJ-11 connector cable (see
48).
Service access cover on page
60)
65)
67)
71)
Video card fan/heat sink assembly on page
Processor heat sink on page
107)
RJ-11 connector cable on page
50).
86)
113)
Component replacement procedures 115
84)