Add A Waypoint Target Or Trolling Grid - Humminbird HELIX 5 SERIES Operation Manual

Cancel Navigation: From the Navigation X-Press Menu, select Cancel Navigation, and press the
RIGHT Cursor key. Canceling navigation removes the route and any waypoints created using the
GOTO key, but it does not remove any saved routes from memory. You will be prompted to save
the current route when you cancel navigation.

Add a Waypoint Target or Trolling Grid

The Waypoint Target shows a target consisting of concentric circles in various distance ranges
centered on the waypoint you choose. The Trolling Grid shows various distance ranges in grid
format from the waypoint you choose. The trolling grid can be used as a guide when trolling around
a waypoint.
Add a Waypoint Target: Open the Waypoint Management dialog box and select a Waypoint.
Press the RIGHT Cursor key, and select Target. Press the RIGHT Cursor key.
Add a Trolling Grid: Open the Waypoint Management dialog box and select a Waypoint. Press
the RIGHT Cursor key, and select Grid. Press the RIGHT Cursor key. The grid can also be rotated
to any heading by adjusting the Grid Rotation setting on the Navigation Main Menu.
Remove a Target or Trolling Grid: Press the MENU key once, and choose Remove Target or
Remove Grid from the Navigation X-Press Menu, and press the RIGHT Cursor key.
NOTE: Only one waypoint can have either a target or a grid applied to it at one time. If you apply a
target or a grid to a new waypoint, the original waypoint will lose its target or grid.
NOTE: The spacing of the rings on the waypoint target and the spacing of the grid lines on the trolling
grid are the same as the length of the scale bar on the left edge of the display. Zooming in or out will
decrease or increase the spacing, respectively.
Chart View with Target
1
1
Map Scale
2
Waypoint Target
2
1
Map Scale
2
Waypoint Trolling Grid
63
Chart View with Grid
1
Introduction to Navigation
2