With Handle And Carburetor Heating System - Stihl MS 341 Shop Manual

– If necessary, remove the front
handle with handle heating –
b 14.5
– If necessary, remove the heater
switch – b 14.6
Install in the reverse sequence.
2
1
: Position the wires (1) under the
switch shaft (2).
On machines with
QuickStop Super
1
: Position the wires (arrows) under
the brake cable (1).
MS 341, MS 361, MS 361 C
: Make sure the ground wire (1)
and short circuit wire (2) are
correctly positioned (see arrows).
Install all other parts in the reverse
sequence.
14.8.3 With Handle and
Carburetor Heating
System
1
2
– Separate the crankcase from the
tank housing – b 12.9
– Remove the short circuit wire –
b 10.1
– Remove the ground wire – b 7.2
: Pull wires with connectors (1 + 2)
out of the retainers (arrows).
– Separate the connectors and
remove the heating elements.
2
: Take the suction hose (1) out of
the guide.
: Pull the wires (2) forwards and
out of the guide.
1 2
1
101