Stihl MS 341 Shop Manual page 28

: Attach the coasting brake
cable (1) to the hole (arrow) in the
brake lever (2).
3
: Position bearing boss of the hand
guard (1) against the pivot pin
and fit the other side of the hand
guard over the fan housing.
: Press the hand guard (1)
carefully downward, and push
the brake lever (2) onto its pivot
pin (3) at the same time.
Coat all sliding and bearing points
with STIHL multipurpose grease –
b 16.
– Lubricate the new brake band
with a few drops of chain oil.
MS 341, MS 361, MS 361 C
2
1
: Attach the spring (1) to the pivot
pin.
1
2
: Fit the screw (arrow) and tighten
it down firmly – b 3.5
: Attach the brake band (1) to the
brake lever (2) and then push it
into the slot in the crankcase
(arrow).
1
: Fit the screw (arrow) and tighten
it down firmly – b 3.5
a a
b
: Turns of brake spring must be
tightly against one another in the
relaxed condition. If this is not the
case, replace the brake spring.
: Check correct position of
protective tube:
a = 31 mm
2
b = 44 mm
1
27