Fuel Hose; Separating Crankcase And Tank Housing - Stihl MS 341 Shop Manual

12.8

Fuel Hose

– Remove carburetor – b 12.2.1
– Remove pickup body – b 12.7
: Pull the fuel hose out of the
retainer (arrow).
: Pry the flange of the fuel hose out
of the fuel tank.
– Pull out the fuel hose.
Install in the reverse sequence.
When installing, make sure the flat
side of the fuel hose points towards
the cylinder.
86
12.9 Separating Crankcase
and Tank Housing
– Drain the fuel tank.
– Drain the oil tank.
Collect fuels and lubricants in clean
containers or dispose of properly in
accordances with regulations.
– Remove the shroud – b 6.2
– Remove the carburetor –
b 12.2.1
– Disconnect the short circuit wire
and ground wire from the ignition
module – b 7.1.2
On machines with handle heating
and/or carburetor heating
– Remove the ignition module –
b 7.1.2
: Pull connector (1) out of guide
(arrow) and disconnect.
1 2
: Pry the grommet (1) out of its
seat and push the wires (2)
inwards.
1
1
2
On machines with handle heating
and/or carburetor heating
: Take out the screw (1).
: Remove the wire (2).
: Take the sleeve (1) out of
the manifold and pull off the
washer (2).
MS 341, MS 361, MS 361 C
1
2