Stihl MS 341 Shop Manual page 35

6.3.1 Preparations
2 1
– Remove the shroud – b 6.2
– Remove the decompression
valve, if fitted – b 6.8
: Install plug (1) 1122 025 2200
and tighten down to 25 Nm.
: Fit spark plug (2) and tighten it
down firmly – b 3.5
– Loosen the muffler screws lightly
– b 6.1
: Fit sealing plate (1)
0000 855 8106 between the heat
shield and cylinder exhaust port
and tighten down the screws
moderately.
34
The sealing plate must completely
fill the space between the two
screws.
– Remove the switch shaft –
b 10.1
– Remove the carburetor –
b 12.2.1
– Set the piston to top dead center.
This can be checked through the
inlet port.
: Check that the sleeve (1) and
washer (2) are in place.
1
: Fit the test flange
1128 850 4200 (1).
: Fit the sleeves (2)
0000 963 1001.
: Fit nuts (3) and tighten them
down firmly.
1
2
2
3
MS 341, MS 361, MS 361 C
1