Between Crankcase And Tank Housing - Stihl MS 341 Shop Manual

9.1.3 Spring, Annular Buffer
between Crankcase and
Tank Housing
2 1
– Remove the spring between the
front handle and cylinder –
b 9.1.1
– Remove the annular buffer
between the tank housing and
crankcase – b 9.1.2
– Remove the chain catcher –
b 5.2
: Carefully pry out the spring (1)
with bearing plug (2).
1
: Pry out the annular buffer (1).
66
1 2
: Use a suitable tool to unscrew the
spring (2) from the tank housing.
: Use a suitable tool to unscrew the
bearing plug (1) from the spring
(2).
: Pull off the annular buffer (3).
Reassemble in the reverse
sequence.
1
2
: Use a suitable tool to screw the
bearing plug (1) on to the spring
(2) as far as stop (arrow).
3
2
: Push the annular buffer (1) into
position (tapered end must face
the spring).
: Use a suitable tool to screw home
the spring (2) as far as stop
(arrow).
2
: Carefully fit the spring (1) with
bearing plug (2).
The bearing plug must be fully
recessed in the crankcase.
– Install the chain catcher – b 5.2
Reassemble all other parts in the
reverse sequence.
MS 341, MS 361, MS 361 C
1
1