Changing The Presser Foot - JUKI MO-1000 Instruction Manual

Using the machine / 使用操作机器
C
D
15

Changing the presser foot

• Switch the machine off (power switch"0") and deactivate the upper knife.
• Raise the presser foot.
• Turn handwheel towards you until needles are fully raised. Match the match-
ing up marks on handwheel and side cover.
Press the catch (C) to release the presser foot from the clamp. Raise the press-
er foot shank to the highest position (B) and remove the presser foot to the
left. To attach the presser foot, place it under the shaft. The groove in the shaft
should line up exactly with the presser foot pin (D). Lower the presser foot lift-
ing lever and check that the groove in the shank should line up exactly with the
presser foot pin (D). If it is not lined up, press the catch (C) to line up.
更换压脚
• 关闭电源（电源开关"0" ）
• 抬升压脚
• 朝自己的方向转动手轮，直至机针达到最高点。
按下 C 部，拆下压脚。
在安装压脚时，要将压脚扳手抬升至最高位（B） ，将压脚放置在其下方，将压脚
上的销对准压脚夹具的槽（D） ，一旦放下压脚扳手即可自动安装上去。