Xerox WorkCentre 5022 User Manual page 53

- Community Name (Read/Write):
You can enter the community name to acquire/write (up to 32 ASCII code characters).
(Default: blank (private))
- Trap Community Name:
You can enter the community name for trap notification (up to 32 ASCII code characters).
(Default: blank (SNMP_trap))
- System Administrator's Login ID:
You can enter information related to the person in charge of maintenance of the machine (up
to 127 ASCII code characters)(Default: blank).
Authentication Failure Generic Traps
You can check Enabled to send an authentication failure trap notification when an access attempt was
made with an invalid community name not registered in the machine. (Default: On)
Advanced button
You can make the following settings by pressing this button:
• Add UDP IPv4 Address button
You can add a recipient address for UDP IPv4 trap notification by pressing this button.
- IP Address:
You can enter the IP address for entry.
- UDP Port Number:
You can set the UDP port No. for entry (a value between 1 and 65535).
- SNMP Version:
You can specify the SNMP version for entry as v1 or v2c. (Default: SNMP v1)
- Trap Community Name:
You can enter the trap community name for entry (between 1 and 32 ASCII code characters).
(Default: SNMP_trap)
- Trap to be Received:
You can set whether to send notification of Print, Cold Start, and Authentication Failure
events.
• Add UDP IPv6 Address button
You can add a recipient address for UDP IPv6 trap notification by pressing this button.
- IP Address:
You can enter the IP address for entry.
- UDP Port Number:
You can set the UDP port No. for entry (a value between 1 and 65535).
® ®
Xerox WorkCentre 5022/5024 Multifunction Printer
User Guide
Environment Settings
2-25