Cylinder Head Removal - KYMCO SUPER8 50 2T Service Manual

6
. CYLINDER HEAD/CYLINDER/PISTON
CYLINDER HEAD
REMOVAL
Remove the rear carrier.
Remove the frame body cover. ( 12-5)
Remove the spark plug cap.
Remove the three bolts attaching the fan
cover to remove the fan cover.
Remove the two joint lock nuts on the front
of the exhaust muffler and then remove the
two exhaust muffler lock bolts.
Remove the bolt attaching the engine hood
to remove the engine hood.
The installation sequence is the reverse of
removal.
＊
When installing the exhaust muffler, first
tighten the two nuts on the front and
then tighten the two bolts.
Remove the spark plug.
Remove the cylinder head bolts and the
cylinder head.
＊
Loosen the bolts diagonally in 2 or 3
times.
Remove the cylinder head gasket.
6-3
Fan Cover/Engine Hood
Bolts
Cylinder head Bolts
Spark Plug
SUPER8 50 2T
Spark Plug Cap
Bolt
Cylinder Head