Starter Relay Inspection; Starter Motor Removal - KYMCO SUPER8 50 2T Service Manual

15
. ELECTRICAL EQUIPMENT

STARTER RELAY INSPECTION

Remove the foot-floor cover.
Disconnect the starter relay coupler and
then remove the starter relay.
Connect the starter relay (D) terminal to the
12V battery positive (+) terminal and the
relay (C) terminal to the battery negative (-)
terminal. Check for continuity between
the starter relay (A) and (B) terminals.
The relay is normal if there is continuity.

STARTER MOTOR REMOVAL

Disconnect the starter motor cable.
Remove the two bolts attaching the starter
motor and remove the starter motor.
The installation sequence is the reverse of
removal.
SUPER8 50 2T
Bolts
Starter Motor
Starter Relay
15-12