KTM 2011 690 SMC EU Repair Manual page 95

14 BRAKE SYSTEM
–
Remove screw cap
–
Draw the old brake fluid out of the brake fluid reservoir using a syringe and fill with
fresh brake fluid.
Bleed syringe (50329050000) (
Brake fluid DOT 4 / DOT 5.1 (
301893-10
–
Pull off protection cap
(standard workshop equipment).
–
Release bleeder screw
Info
During suction, ensure that the brake fluid reservoir is always filled with a
sufficient amount of fresh brake fluid.
–
Tighten the bleeder screw. Remove the suction device and mount the protection
cap.
302043-10
–
Add brake fluid to the MAX mark.
Brake fluid DOT 4 / DOT 5.1 (
–
Mount the screw cap with the washer and membrane.
–
Activate the foot brake lever until there is a firm pressure point.
Info
Clean up overflowed or spilt brake fluid immediately with water.
with washer and membrane
1 3
p. 210)
p. 206)
and connect a commercially available suction device
4
and draw out the old brake fluid.
5
p. 206)
.
2
93